The Model 10 weighs more than 15 kg (33 lbs) but is only 304 mm in diameter, thus meeting all the requirements of high density construction that is required to maintain freedom from colouration. The turntable is supported on three large polymer isolators inside adjustable feet that allow for quick and easy levelling. A trilateral sub-chassis that is carried on three polymer loaded towers; a novel design which allows impressive isolation without floating. Fully machined platter providing extensional damping, with a diamond turned top surface with a fine scroll finish for an optimal record interface. Large diameter reflex record clamp ensures largest possible contact between platter and record.
The turntable is driven by a 3 phase, brushless outrunner motor with 8-pole Neodymium magnets and 3 integrated Hall effect sensors and virtually vibrationless by reason of its 2.5 kg (5.5 lbs) weight as well as being isolated on urethane mounts that are adjustable for accurate belt positioning. The electronic controller uses a high performance microprocessor, optimised for motor control. Closed loop speed control is implemented using a proportional plus integral (PI) algorithm. Fine pitch speed adjustment allows increments/decrements of +/-0.01% of selected speed. Speed ranges: 33.3, 45 & 78 rpm.